Skip to main content

Text by center

Text by center
This is a free plugin!
Creating or aligning single-line text in the middle between two specified points

Call options

  • ModPlus floating menu or palette
  • Menu, toolbar, or ribbon in nanoCAD
  • Command line: _mncTxtCenter

Icon

mncTxtCenter_32x32 mncTxtCenter_16x16 mncTxtCenter_32x32_dark mncTxtCenter_16x16_dark

Using

Plugin works in two modes:

  • create a new one-line text in the middle between two points
  • align the existing one-line text in the middle between two points.

Plugin starts with the mode in which it was completed in the previous use. When the alignment mode of existing single-line text is used, pre-selection processing is used – first select single-line text, then start plugin.

The one-line text "Justification" property is automatically changed to "Middle center".

Plugin is cycled until canceled by the user.

By default, the plugin starts with the mode New.

New:

Specify the first point or [Existing]: – specify the first point of the alignment line or go to the Existing mode. 

Enter text: – enter text content of the one-line text to be created.

Specify the second point: – specify the second point of the alignment line.

Existing:

Select single line text or [New]: – select an existing single-line text or go to New.

Specify the first point: – specifying the first point of the alignment line.

Specify the second point: – specify the second point of the alignment line.